GARBAFLEX CrSi75
Flat and shaped wire
GARBAFLEX CrSi75 is especially intended for application requiring high fatigue properties and good relaxation properties at moderately increased working temperatures.
| C (%) | Si (%) | Mn (%) | Cr (%) | V (%) | P max. (%) | S max. (%) |
|---|---|---|---|---|---|---|
| 0.50 - 0.70 | 1.20 - 1.65 | 0.50 - 0.80 | 0.50 - 1.00 | 0.05 - 0.20 | 0.020 | 0.020 |
For flat rolled wire
| Width (mm) | Tolerance (mm) |
|---|---|
| 1.00 - 5.00 | ±0.050 |
| 5.01 - 8.00 | ±0.070 |
| 8.01 - 10.00 | ±0.100 |
| Thickness (mm) | Tolerance (mm) |
|---|---|
| 0.30 - 0.80 | ±0.013 |
| 0.81 - 1.00 | ±0.019 |
| 1.01 - 1.60 | ±0.025 |
| 1.61 - 2.30 | ±0.050 |
For shaped wire
| Width (mm) | Tolerance (mm) |
|---|---|
| 1.50 | ±0.020 |
| 1.51 - 3.00 | ±0.030 |
| 3.01 - 5.00 | ±0.040 |
| 5.01 - 7.00 | ±0.050 |
| 7.01 | ±0.060 |
Microstructure
Tempered martensite with no ferrite.
Execution
Rolled on 2 sides (flat).
Rolled on 4 sides (shaped).
Profile drawn (shaped).
Camber
Max. 4 mm measured on 1 m length.
Coil set
Max. 20 mm measured on 1 m length.
Surface
Bright or oxide.
Surface defects max. 1% of thickness.
Density: 7.95 kg/dm3.
E and G modulus of elasticity
206 kN/mm²
E and G modulus of shear
79.5 kN/mm²
Additional information
Decarburization
No total decarburisation. Partial decarburisation (no continuous zones) max. 1.2% of a corresponding round wire dimension.